Skip to content

Free roof inspection that checks the small stuff too: (317) 743-3417

Cumberland · Lawrence · New Palestine · Greenfield

(317) 743-3417
Two roofers in safety harnesses install shingles along the hip of a gray asphalt roof above vinyl siding, with a ladder, gutter and dump trailer below on an overcast day

Roofing in Cumberland, Built to Last at the Flashing, Vents and Edges

We replace and repair roofs in Cumberland, and we do shingle, metal and TPO work, gutters, storm damage repair and roof inspections. Most leaks start at a flashing joint, a vent boot or a nail set wrong, so that is where we spend our time. We also work in Greenfield, New Palestine and Lawrence.

  • Free roof inspections
  • Financing available
  • Help with storm claims
  • Flashing set by hand

Roofing Services for Your Home

We handle roof repair and full roof replacement, along with shingle roofing, metal roofing and TPO roofing for low-slope sections like porches and additions. After hail or wind, our storm damage repair work starts with a careful look and clear photos. We also install and fix gutters, since a roof only works if the water has somewhere to go. Not sure what you need? Roof inspections are where most jobs begin.

  • Two roofers installing dark architectural shingles over bare decking on a ranch house, with a dump trailer of torn-off shingles in the driveway

    Roof Replacement

    Full tear-off to the deck, new underlayment, flashing and ventilation, installed with the small details that decide how long a new roof lasts.

  • Roofer kneels on a vinyl-sided home's roof nailing new dark shingles beside bare plywood decking, with a ladder at the eave and a dump trailer of torn-off shingles below

    Roof Repair

    Leak tracing, flashing, pipe boots and shingle repairs installed to manufacturer specs, with photos of what we found and what we fixed.

  • Roofer in a yellow safety harness kneeling on underlayment, drilling a dark standing-seam metal panel on a house roof, with spare panels and a ladder at the eave

    Metal Roofing

    Standing seam and exposed-fastener metal roofs, with panels fastened to move with the heat and flashing bent to fit your home.

  • Roofer kneeling on a charcoal architectural shingle roof using a nail gun, with a shingle bundle on underlayment and a ladder at the gutter edge

    Shingle Roofing

    Asphalt shingle roofs installed with correct nail lines, sealed valleys and balanced attic venting, so the roof holds up through hail, wind and freeze-thaw.

  • Roofer kneeling on a white TPO flat roof, heat-welding a membrane seam with a hand welder near a roof drain and parapet edge

    TPO Roofing

    Single-ply TPO for the flat and low-slope parts of your home, with welded seams, built-in drainage and edges flashed to shed water.

  • Roofer on an aluminum ladder at the eave holding a clipboard while inspecting asphalt shingles, roof vents and a vent pipe on a suburban home on an overcast day

    Roof Inspections

    A free, close look at your shingles, flashing, vents and attic, with photos and a straight answer on what needs work and what can wait.

  • Roofer kneeling on a storm-damaged asphalt shingle roof near a valley, with missing shingles, exposed decking, a blue tarp battened down and a ladder at the gutter

    Storm Damage Repair

    Hail dents, lifted shingles and torn flashing found, photographed and fixed, with help working through your insurance claim.

  • Worker on an aluminum extension ladder fastening a white gutter along the eave of a ranch house with gray vinyl siding, brick base and a white downspout

    Gutters

    Gutters formed on site to the length of each eave, hung on close-set hidden hangers, pitched to drain and fed into downspouts that carry water clear of your home.

Roofing crew carries shingle bundles from a white van in a driveway toward a split-level brick home with a ladder and partly sheathed roof

A Small Roofing Company That Sweats the Details

Roofing Cumberland is a local roofing company that works on homes in Cumberland and the towns around it. We do roofs and gutters, and that is it. Keeping the work focused lets us get good at the parts most people never see.

Indiana roofs get a hard workout. Winters bring freeze and thaw cycles that open up weak seams, and spring storms push wind and hail across the roof. A roof that holds up to that is one where the starter row is sealed, the drip edge is lapped right and the valleys are cut clean. We would rather spend an extra hour on those things than come back for a leak next March.

License
Licensed
Insurance
Bonded and insured
Certifications
Owens Corning Preferred Contractor

How a Job Runs

Most jobs follow the same few steps. You hear what is coming before it happens.

  1. 1

    Free inspection

    We get on the roof and into the attic when we can. We look at shingles, flashing, vents, gutters and any sign of moisture, taking photos along the way.

  2. 2

    Plain answer and estimate

    We sit down with the photos and explain what we found. You get a written estimate with every item listed and our honest view on repair versus replacement.

  3. 3

    Work day

    Landscaping gets covered and the driveway protected before tear-off. On a replacement we strip the old roof, check each sheet of decking, then put down underlayment, flashing and shingles in order. Most homes wrap up in a day or two, weather allowing.

  4. 4

    Cleanup and final look

    Debris gets hauled off and a magnet goes over the yard and driveway to catch stray nails. Before we leave, we go around the house with you so you can see the finished flashing, edges and vents for yourself.

Roofer in a yellow harness kneels near the eave, lifting a loose asphalt shingle over exposed decking while holding a clipboard, with a ladder and suburban street below

What Moves the Price of a Roof Job

Every roof prices out differently, and a number given over the phone before anyone climbs up is a guess. These are the things that change the cost on your home. After the inspection, we can attach a real figure to each one. Financing is available if spreading the cost out helps.

Your estimate comes from what we see during the free inspection, written out item by item. If something unexpected turns up after tear-off, we stop and show you before going on.

Square footage and pitch
Square footage decides how many bundles go up and how many hours the crew spends. Pitch matters too. On a steep slope the crew works tied off and moves slower, so labor climbs.
The decking underneath
Nobody can see the plywood until the old shingles are gone. Soft or rotted boards get replaced before new material goes down, and your estimate lists the cost per sheet ahead of time so the final bill makes sense.
Old layers coming off
Some older homes carry two layers of shingles. Every extra layer means more weight to haul, more tear-off time and more disposal.
Material choice
Architectural shingles, standing seam metal and TPO membrane each carry a different price and a different lifespan. We lay out the trade-offs for your roof.
Penetrations and details
Chimneys, skylights, valleys and plumbing vents all need flashing. The more of them your roof has, the more slow hand work goes into it.
Gutters and ventilation
When gutters or attic vents need attention, doing them with the roof often saves a second trip. They show up as their own lines, so the choice stays yours.

Towns We Cover

We roof homes in Cumberland and across the east side of the Indianapolis area. Lawrence, Beech Grove, New Palestine and Greenfield are regular stops for our crew, and so are McCordsville, Fortville and Ingalls. We also head north for jobs in Fishers, Carmel and Noblesville.

  • Cumberland
  • Lawrence
  • New Palestine
  • Greenfield
  • Beech Grove
  • McCordsville
  • Fishers
  • Fortville
  • Ingalls
  • Carmel
  • Noblesville

If your street sits just past these towns, mention it on the call. We will tell you straight whether we can reach you and do the job right.

More on the areas we cover

10 miLawrenceNew PalestineGreenfieldBeech GroveMcCordsvilleFishersFortvilleIngallsCarmelNoblesvilleCumberlandN

Questions We Hear a Lot

Does the inspection cost anything?

No. A roofer climbs up, checks the attic when there is a hatch we can reach, and photographs anything worth your attention. You keep the photos and the estimate. If you decide not to go ahead, you owe us nothing.

Should I fix my roof or replace it?

Three things decide it: how old the roof is, how much of it is damaged and what shape the decking is in. One bad spot on a roof that is otherwise sound is usually a good candidate for a repair. If the shingles are brittle or curling and granules are washing into the gutters all over, patching just buys a little time. We walk through the photos with you and tell you which way we would go on our own house.

Can you help after a storm hits my roof?

Yes. We work with homeowners and insurance companies on storm damage claims. We record the damage with photos and measurements, and we can be there when the adjuster comes out. The adjuster decides what is covered. Our part is making the damage easy to see.

What warranty comes with the work?

You get a 2-year labor warranty, and it can be upgraded to 10 years through Owens Corning. Ask about the upgrade during your inspection and we will explain how it applies to your roof.

Can new shingles go right over my old ones?

Sometimes a second layer is allowed, but we almost always recommend a full tear-off. With the old roof off, we can check every sheet of decking and set new flashing and drip edge correctly. Laying over the top hides problems and adds weight.

Do you offer financing?

Yes, financing is available. If a new roof is more than you want to pay all at once, bring it up during your inspection and we will go through how it works.

How long does a roof replacement take?

Most homes are done in one or two days. A large roof, a steep pitch or a lot of rotted decking can add time. Rain can push us back a day, because we will not leave your home open to the weather.

Shingle, metal or TPO: which should I pick?

Shingles suit most pitched roofs and most budgets. Metal costs more at the start, lasts longer and lets snow slide off. TPO belongs on flat or low-slope areas like a porch roof or an addition, where shingles would not shed water. We will tell you what fits each part of your roof.

Why Homeowners Hire Us

A roof rarely fails in the middle of a shingle. It fails at the edges, the seams and the holes cut for pipes and vents. We build those spots like they matter, because they do.

Licensed, bonded and insured

We are licensed, bonded and insured. You can ask about any of it when we come out for the inspection.

Owens Corning Preferred Contractor

We are an Owens Corning Preferred Contractor. We install their shingles with the matching underlayment, starter strip and ridge cap, not a mix of parts picked to save a few dollars.

Nails where they belong

Each shingle has a nailing strip for a reason. We keep nails on that line and set flush, not overdriven or crooked. A nail driven too deep or too high is a common reason shingles lift in strong wind.

Flashing done the slow way

Step flashing gets woven in piece by piece along walls and chimneys. Worn pipe boots get replaced, not smeared with caulk. Caulk is a patch, not a fix.

Photos of what we find

After every inspection you get pictures of the trouble spots, so you see what we saw. From there we give you a straight call on whether fixing it makes sense or the roof has reached the end.

Elevated view of a charcoal asphalt shingle roof with hip ridges, a valley, roof vents and a pipe vent, an aluminum ladder at the gutter, and a tree-lined street behind

Let Us Take a Close Look

We will check the shingles and the spots most roofers skip, like flashing, boots and the drip edge. You get photos and a plain answer on what your roof needs.